Enterprise News

Action of by-pass valve of conduction oil furnace and low an oil groove is basic requirement

   Conduction oil furnace, its are the common sort of boiler, in the meantime, also be website product and keyword, should take seriously on study manner so rise, cannot have the least bit and careless and lax. And below, it is to conduction oil furnace the introduction of this kind of boiler explains, pass a few relevant knowledge or a few problems, such, also can let everybody have study content, then, will advance the learning process of this product.

  1. The oil gas segregator in conduction oil furnace, where are its installation is in commonly?

  The oil gas segregator in conduction oil furnace, its are installation commonly be exported in conduction oil and use hot device between. Posture buy is provided to go up in its, can examine boiler to install technological arrangement plan, because above meeting mark outpour comes, so that let everybody have clear knowledge, such, also can avoid segregator to install the position to make mistake.

  2. In conduction oil furnaceBy-pass valve, what is its action?

 In conduction oil furnaceBy-pass valve, its main effect, be flow for discharge and pressure regulating, can run actual condition according to boiler, come to what adjust by-pass valve appropriately leave degree. If conduction oil gives oily mouth pressure too big, can increase by-pass valve leave degree, conversely, can close by-pass valve. So, this is one important part, cannot lack.

  3. Natural gas conduction oil in furnace, whether is use temperature controller necessary?

  Natural gas conduction oil in furnace, the word of use temperature controller, will tell from professional point of view, dispute often is necessary. Because, if be not used lukewarm accuse implement if, so, cannot undertake be controllinged effectively to boiler temperature, then, cannot provide a few specific data, will help boiler be mixed normally move smoothly.

   4. In conduction oil furnace low an oil groove, what is main to its demand?

  In conduction oil furnace low an oil groove, to its main demand, it is to be its to be on the capacity, the conduction oil that can deposit whole system is measured, because have only such, the regular job that just can assure conduction oil furnace and move. And, this also is main demand, must want to satisfy, otherwise, low oil groove cannot be used.