Enterprise News

The distinction of different tonnage mixes steam boiler how to produce overheat steam

Steam boiler, this is boiler one specific sort, and it is to be in website product, so need has comprehensive understanding and knowledge, such ability come correct and reasonable the performance characteristics that use and lets this product had had and use effect. So, be based on this, it is to undertake steam boiler next of relevant knowledge explain the job, it may not be a bad idea gains the professional knowledge that increases this respect.

1.Whether do 4 tons of steam boiler mix 6 tons to there is distinction?

Steam boiler, its are to be able to have different tonnage, for instance 4 tons mix 6 tons. Undertake the steam boiler of these two tonnage comparative, the conclusion that can reach is, they are to have a few distinction, besides outside differring on tonnage, also be different on boiler norms dimension. And, below rated power, 4 tons of steam boiler offer 4 tons of vapour hourly, 6 tons of steam boiler offer 6 tons of vapour hourly.

2.After power cut, what work should steam boiler do?

In steam boiler moving process, if appear power cut accident, direct current source of distribution room lash-up or start automatically, boiler operation personnel is OK open reserves power source illume. In the operation when power cut, should ask by the regulation and undertake orderly, can avoid boiler to be affected so.

3.What kind of steam boiler can just produce overheat steam? How much is the backwater quantity of 10 tons of steam boiler?

Want steam boiler to produce overheat steam, it is to ask to there is superheater on boiler this one component. In addition, if be to remove the moisture in saturated vapour only, also can pass heat exchanger to turn low pressure into saturated vapour with high-pressured saturation vapour, vapour of its low pressure also can form overheat vapour, can reduce moisture content at the same time.

10 tons of steam boiler, if its backwater quantity mentions consideration normally, it is to use backwater quantity to be equal to capacity this one formula, use corporeal conversation law. Nevertheless, on boiler room design, even if is vapour condensate reclaims entirely, 80% actual backwater quantity also can be output vapour quantity only, general short of 90% . So, everybody should have accurate knowledge on this, cannot make mistake.